Enlarged surface for the gear selector on the left combination switch

Control unit for adjusting the heated seat and heated grips through the combination switches and the dashboard.

WIRING HARNESS FOR SEAT HEATING (A62611986000) - Required

KTM ERGO RIDER'S SEAT - Required
(A62607940016C1A) same height
(A62607940018C1A) Higher
(A62607940014C1A) Lower

CNC milled from high-strength aluminum
Elegant anodised surface
Extremely light
Visual highlight with technical and ergonomic added value
Perfect for use on the race track
Adjustable grip width
Flaps removed on ground contact
Prevents broken levers

Made of high-strength aluminum
Tested in complex and specially-developed test cycles
Position markings for easy adjustment

Dimensions: A = 115 mm, B = 806 mm, C = 62 mm

CNC milled from high-strength aluminum
Elegant anodised surface
Integrate perfectly into the vehicle design
Visual highlight
Ball joint, for flexible adjustment of the rear mirror
Including adapter for mounting

CNC milled from high-strength aluminum
Elegant anodised surface
Extremely light
Visual highlight with technical and ergonomic added value
Adjustable grip width
Flaps removed on ground contact
Prevents broken levers

Required Articles:
FACTORY RACING STEERING DAMPER (58512050100)
STEERING DAMPER BRACKET (79012960100)

Uncompromising race look
Extremely light
Open design

Attached directly at the levers with a special mounting.
Only mountable with Brembo brake system

High-quality look
Integrate perfectly into the vehicle design
Modern and simple design
Plug & Play mounting
Increased safety due to extremely bright flashing light
Visual highlight

- Small design: width approx. 2 mm, length approx. 73 mm
- Contains 4 LED turn signals
- Make sure the latest version of the software is installed on the vehicle

Makes it easier to stand your motorcycle up
Fastened to the silencer support on the subframe
Essential under extreme off-road conditions
Strap made from high-strength nylon

Tested in complex and specially-developed test cycles
Made of high-strength aluminum
Position markings for easy adjustment
Comes with handlebar pad

CNC milled from high-strength aluminum
Elegant anodised surface
Modern, subtle, and timeless design
Visual highlight
Ball joint, for flexible adjustment of the rear mirror
Adjustable handle

Uncompromising race look
Extremely light
Open design

Attached directly at the levers with a special mounting.
Only mountable with Brembo brake system

Right grip permanently glued to the throttle grip
Left grip with aluminum clamping ring for fixing on the handlebar
Inconvenient gluing and securing with wire no longer necessary
The different guide plates allow a variation of the throttle valve opening.

High-end steering damper
Maximum control on fast tracks
Gain in stability at the front wheel
Fully adjustable
Well thought-out mounting of the damper enables individual handlebar adjustment
Reduced weight
Sensitive response behavior
High speed DCC
Developed according to the requirements of our factory drivers
Optimum 25 click setting range.
Proven success with the KTM Works Rally Team.
For use on Enduro MY21 and later (EU Version), the Factory fuel tank cap vent is required

Required Article:
STEERING DAMPER COUNTER BEARING (77212905444)
STEERING DAMPER BRACKET (58512050144)